Chevrolet Sonic manuals

Chevrolet Sonic Owner's Manual: Power Steering Warning Light

This light comes on briefly when the ignition is turned to ON/RUN as a check


This light comes on briefly when the ignition is turned to ON/RUN as a check to show it is working.

If it does not come on have the vehicle serviced by your dealer.

If this light stays on, or comes on while driving, the system may not be working. If this happens, see your dealer for service.

Up-Shift Light
For manual transmission vehicles, there is an up-shift light that comes on in the lower DIC area. It shows when to shift to the next higher gear for best fuel economy. See Manual Transmission. ...

Lane Departure Warning (LDW) Light
This light comes on briefly while starting the vehicle. If it does not, have the vehicle serviced by your dealer. If the system is working normally, the light then turns off. This light comes o ...

Other materials:

Stop and Turn Signal Lamp Bulb Replacement (Sedan)
Stop and Turn Signal Lamp Bulb Replacement Callout Component Name Preliminary Procedure Remove the tail lamp assembly. Refer to Tail Lamp Replacement. 1 Tail Lamp Socket Procedure Rotate the ...

Neutral - Engine Running (Gen 2)
When the gear selector is moved to the Neutral (N) position, the hydraulic and electrical system operation is identical to Park (P) range. However, if Neutral is selected after the vehicle was operating in Reverse (R), the normally-low 35R pressure control solenoid is commanded OFF and the fol ...

Crankshaft Position System Variation Learn
Note: The crankshaft position sensor system variation learn procedure is required when the following service procedures have been performed, regardless of whether DTC P0315 is set: Engine replacement Engine control module (ECM) replacement Crankshaft damper replacement ...

В© 2014-2026 Copyright www.csmans.com
 
0.0055