|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the windshield outside moisture sensor cover. Refer to Windshield Outside Moisture Sensor Cover Replacement. |
|
|
1 |
Remote Control Door Lock Receiver Procedure
|
Remote Control Door Lock Receiver Programming and Setup
Remote Keyless Entry (RKE) System OperationEmblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Cylinder Head Disassemble
Special Tools
EN-840 Pliers/Remover
EN-8062 Valve Spring Compressor
EN-8062-5 Adapter
EN-50717-2 Compressor Assembly of EN-50717 Kit
For equivalent regional tools, refer to Special Tools.
Install the EN-50717?E assembly (1) to the EN-8062 compressor
(4).
Install the E ...
Engine compartment check locations
Window washer fluid reservoir
Fuse/fusible link holder
Engine oil filler cap
Engine oil dipstick
Brake fluid reservoir
Battery
Engine coolant reservoir
Radiator filler cap
Drive belts
Air cleaner
VR35DDTT engine
NOTE:
Depending on the configuration of your Nissan Arma ...