Chevrolet Sonic Repair Manual: Transmission Control Lever Boot Replacement
|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the front floor console. Refer to Front Floor Console Replacement. |
|
|
1 |
Shift Control Lever Knob Cover Procedure
Using a flat-bladed tool, remove the shift knob cover. |
|
2 |
Fastener |
|
3 |
Shift Control Lever Knob and Boot Assembly |
Transmission Case Disassemble (Gen 2)
Special Tools
3-9506289 Universal Adapter
J-810700 Mainshaft Bearing Remover
J-810704 Center Bar Puller
M-680770 Universal Sliding Mallet
R-0007758 Holding Fixture
R-0007770 Holding F ...
Transmission Control Replacement
Removal Procedure
Remove the floor console. Refer to
Front Floor Console Replacement.
Lift both cable adjustment retainers (1), one for
each cable, to release the s ...
Other materials:
Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
Special Tools
EL-49642 SPS Programming Support Tool
For equivalent regional tools, refer to Special Tools.
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the ECU is not properly configured with the correct
calibration ...
Fuel Pump Control Module Programming and Setup
The fuel pump control module must be programmed with the proper calibration software.
The module stores and utilizes this information however if it is not properly configured
with the correct calibration software, the fuel pump control module will not control
all of the vehicle features proper ...
Bushing and Mating Shaft Inspection
Note: Proper bushing and corresponding mating shaft inspection should
be performed before replacing the bushing, shaft, and in some cases, the component
which houses the bushing. Thoroughly clean and dry the bushing and shaft surfaces
before inspecting for damage.
Any of the followin ...
0.0092