Chevrolet Sonic Owner's Manual: When the System Does Not Seem to Work Properly
The RVC system may not work properly or display a clear image if:
- The RVC is turned off. See “Turning the Rear Camera System On or Off” earlier in this section.
- It is dark.
- The sun or the beam of headlamps are shining directly into the camera lens.
- Ice, snow, mud, or anything else builds up on the camera lens. Clean the lens, rinse it with water, and wipe it with a soft cloth.
- The back of the vehicle is in an accident. The position and mounting angle of the camera can change or the camera can be affected. Be sure to have the camera and its position and mounting angle checked at your dealer.
Rear Vision Camera Location
The camera is above the license plate.
The area displayed by the camera is limited. It does not display objects that
are close to either corner or under the bumper and can vary depending on vehic ...
Lane Departure Warning (LDW)
For vehicles with this feature, read the entire section before using it.
Warning
The LDW system is an aid to help the vehicle stay in the driving lane. It
does not steer the vehicle. The LDW syste ...
Other materials:
Tire Pressure Indicator Sensor Learn
Special Tools
EL-46079 Tire Pressure Monitor Diagnostic Tool
EL-50448 Tire Pressure Monitor Sensor Activation Tool
For equivalent regional tools, refer to Special Tools.
Learn Mode Description
The tire pressure monitor system uses the instrument cluster, body control
module ...
Clutch and Differential Housing Disassemble
Special Tools
M-680770 Universal Sliding Mallet
R-0007758 Holding Fixture
R-0407008 Counter Shaft Bearing Remover
R-0407010 Input Shaft Needle Bearing Puller and Driver
R-0407013 Gearshift Device Bushing Puller
R-0007761 Universal Handle for Pullers and Installers
T-0207928 Retai ...
Engine oil
Checking engine oil level
Vehicle set-up
To ensure accurate engine oil level readings in your Nissan Armada, follow the
proper preparation steps below.
1. Park the Nissan Armada on a flat, level surface and securely apply the parking
brake.
2. Start the engine and allow it to reach no ...
0.0059