Chevrolet Sonic Owner's Manual: Driving and Operating
- Driving Information
- Distracted Driving
- Defensive Driving
- Drunk Driving
- Control of a Vehicle
- Braking
- Steering
- Off-Road Recovery
- Loss of Control
- Driving on Wet Roads
- Highway Hypnosis
- Hill and Mountain Roads
- Winter Driving
- If the Vehicle Is Stuck
- Vehicle Load Limits
- Starting and Operating
- New Vehicle Break-In
- Ignition Positions
- Starting the Engine
- Engine Heater
- Retained Accessory Power (RAP)
- Shifting Into Park (Automatic Transmission)
- Shifting out of Park (Automatic Transmission)
- Parking
- Parking over Things That Burn
- Engine Exhaust
- Automatic Transmission
- Manual Transmission
- Brakes
- Ride Control Systems
- Cruise Control
- Driver Assistance Systems
- Fuel
- Fuel
- Recommended Fuel
- Gasoline Specifications
- California Fuel Requirements
- Fuels in Foreign Countries
- Fuel Additives
- Filling the Tank
- Filling a Portable Fuel Container
- Trailer Towing
- Conversions and Add-Ons
Maintenance
Air Intake
Clear away any ice, snow, or leaves from the air intake at the base of the windshield
that can block the flow of air into the vehicle.
Passenger Compartment Air Filter
The filter remov ...
Other materials:
Underbody Rear Side Rail Extension Replacement
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Warning: Refer to Glass and Sheet Metal Handling Warning.
Disable the SIR System. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer ...
Brake Fluid Effects on Paint and Electrical Components Caution
Caution: Avoid spilling brake fluid onto painted surfaces, electrical
connections, wiring, or cables. Brake fluid will damage painted surfaces and
cause corrosion to electrical components. If any brake fluid comes in contact
with painted surfaces, immediately flush the area with water. I ...
Piston, Connecting Rod, and Bearing Removal
Install the crankshaft balancer bolt.
Set the pistons 1 and 4 to TDC in direction of engine rotation.
Note: Note cylinder sequence.
Mark the connecting rod with the connecting rod bearing cover (1).
Remove the 4 connecting rod bearing caps bol ...
0.0103