Chevrolet Sonic Owner's Manual: Starting the Engine

Ignition Positions

The ignition switch has four different positions. To shift out of P (Park), the ignition must be in ON/RUN and the regular brake pedal applied. 1 (STOPPING THE ENGINE/LOCK/ OFF): When the vehicl ...

Automatic Transmission

Move the shift lever to P (Park) or N (Neutral). The engine will not start in any other position. To restart the engine when the vehicle is already moving, use N (Neutral) only. Caution Do not t ...

Other materials:

Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
Sedan Taillamp Shown, Hatchback Taillamp Similar 1. Back-up Lamp 2. Turn Signal Lamp 3. Stop Lamp/Taillamp 4. Sidemarker Lamp To replace one of these bulbs: 1. Open the trunk. 2. Remove the two screws, which secure the taillamp assembly. 3. Remove the taillamp assembly by pulling it stra ...

Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the proper calibration software. The module stores and utilizes this information however if it is not properly configured with the correct calibration software, the seat heating control module will not control all of the vehicle features ...

Automatic Transmission Flex Plate Installation
Special Tools EN-652 Automatic Transmission Flex Plate Holder For equivalent regional tools, refer to Special Tools. Clean the automatic transmission flex plate bolt threads. Install the automatic transmission flex plate (2) and the EN-652 holder to hold the automatic tran ...