Nissan Armada 2025-2026 Owner's Manual: Basic information
WARNING
Improper loading or exceeding the recommended trailer capacity for your Nissan Armada can significantly affect handling, braking efficiency, and overall performance, potentially leading to dangerous driving conditions or accidents.
CAUTION
- Avoid towing a trailer or carrying heavy loads with your Nissan Armada until it has been driven at least 500 miles (800 km). This initial break-in period is essential to prevent premature wear or damage to the engine, drivetrain, and axle components.
- During the first 500 miles (800 km) of towing, do not exceed speeds of 50 MPH (80 km/h), and avoid rapid acceleration or full-throttle starts. This helps critical components of your Nissan Armada properly adapt to increased load conditions.
- Using premium gasoline with a minimum rating of 91 AKI (Research Octane
Number 96) is highly recommended when towing with your Nissan Armada to maintain
optimal engine performance.
If lower-grade fuel is used—especially in hot weather, on steep inclines, or while towing heavy loads—engine temperature may rise, and power output may decrease due to engine protection systems activating. In such situations, avoid aggressive acceleration to protect your Nissan Armada.
Your Nissan Armada is primarily designed for transporting passengers and cargo, but it is also capable of towing when properly equipped. Keep in mind that towing adds extra stress to the engine, transmission, steering, braking, and suspension systems.
For detailed towing guidelines, refer to the official NISSAN Towing Guide (U.S. only), available at www.nissanusa.com. This resource provides comprehensive information about towing capacities and required equipment for safe trailer operation with your Nissan Armada.
Towing a trailer
...
Maximum load limits
Maximum trailer loads
Never exceed the maximum allowable trailer load specified in the "Towing load/specification"
section. The total trailer load includes both the trailer itself and any ...
Other materials:
Drivetrain and Front Suspension Frame Replacement
Special Tools
EN-45059 Angle Meter
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Support the radiator and condenser from above using the upper brackets
on each side.
Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle.
Re ...
SIR Service Precautions
General Service Instructions
Warning: When performing service on or near the SIR components
or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling
and Enabling . Failure to observe the correct procedure could cause deployment
of the SIR components, person ...
Crankshaft and Bearing Cleaning and Inspection
Special Tools
EN-45059 Torque Angle Sensor Kit
GE-571-B Dial Gauge
For equivalent regional tools, refer to Special Tools.
Crankshaft End Play, Check
Note: Crankshaft attached with crankshaft bearing caps.
Install the GE-571-B gauge (1).
...
0.0062