Chevrolet Sonic Repair Manual: Brake Warning System Description and Operation
- Brake Warning Indicator
-
- Brake Warning Block Diagram
B80 Park Brake Switch B20 Brake Fluid Level Switch K9 Body Control Module P16 Instrument Cluster (HW) Hard-Wired (HW) Hard-Wired (DA) Serial Data (B80) B80 Park Brake Switch (B20) B20 Brake Fluid Level Switch (K9) K9 Body Control Module (P16) P16 Instrument Cluster
The instrument cluster turns the brake warning indicator ON when the following occurs:
- The instrument cluster performs the bulb check. The brake warning indicator illuminates for 5 s.
- When the Electronic Brake Control Module (EBCM) detects low brake fluid level it sends a serial data message to the instrument cluster, which will illuminate the red brake indicator.
- The Body Control Module (BCM) detects that the parking brake is engaged. The instrument cluster receives a serial data message from the BCM requesting illumination.
- Driver Information Center Messages
-
When the Electronic Brake Control Module (EBCM) detects low brake fluid level it sets DTC C0267 and sends a serial data message to the Driver Information Center , which will display Brake Fluid Low message.
Brake System Warning Light
The vehicle brake system consists of two hydraulic circuits. If one circuit is
not working, the remaining circuit can still work to stop the vehicle. For normal
braking performance, both circuits ...
Engine Oil Pressure Indicator Switch Replacement
Engine Oil Pressure Indicator Switch Replacement
Callout
Component Name
Preliminary Procedure
Remove the air conditioning compr ...
Other materials:
SIR Inflator Module Handling and Storage Warning
Warning: When carrying an undeployed inflator module:
Do not carry the inflator module by the wires or connector.
Make sure the air bag opening points away from you.
When storing an undeployed inflator module:
Make sure the air bag opening points away from the surface o ...
Front Brake Rotor Replacement
Special Tools
CH-41013 Rotor Resurfacing Kit
CH-42450-A Wheel Hub Resurfacing Kit
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Warning: Refer to Brake Dust Warning.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
...
Engine Oil and Oil Filter Replacement
Removal Procedure
Open hood.
Place a drain pan below the vehicle.
Caution: To prevent damage to oil filter cap ensure proper
tool is used. Do not use an open end wrench which may cause damage to
filter cap.
Using a 24mm socket or closed end wrench loosen ...
0.0065