
The Nissan Armada BSW system becomes active at speeds above approximately 20 MPH (32 km/h), ensuring effective operation during typical driving conditions.
When another vehicle is detected within the blind spot area, the side indicator light on the corresponding mirror will illuminate.
If the driver activates the turn signal while a vehicle is still present in the detection zone, the Nissan Armada BSW system responds with an audible warning (two chimes), and both the side indicator light and BSW indicator begin flashing. These warnings remain active until the detected vehicle leaves the monitored area.
The side indicator light in the Nissan Armada briefly illuminates when the ignition is turned ON, confirming system readiness.
Additionally, the brightness of the side indicator light automatically adjusts based on surrounding light conditions, ensuring clear visibility both днем and вночі.
Basic information
How to enable/disable the BSW systemFuel Injection Fuel Rail Assembly Replacement
Removal Procedure
Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection
and Connection.
Remove engine cover. Refer to Engine Cover Replacement.
Remove the fuel feed pipe from fuel injection fuel rail. Refer to Fuel
Feed Pipe Replacement.
Re ...
3-5-Reverse and 4-5-6 Clutch Fluid Seal Ring Replacement (Gen 1)
3-5-Reverse and 4-5-6 Clutch Fluid Seal Ring Replacement
Callout
Component Name
Special Tools
DT-46620 Seal Installer
For equivalent regional tools, refer to Special
Tools.
1
3? Reverse and ...
Towing recommended by NISSAN
Four-wheel drive models
Four-wheel Drive (4WD) models
For the Nissan Armada equipped with four-wheel drive, the manufacturer strongly
recommends transporting the vehicle using towing dollies or, preferably, a flatbed
truck to ensure maximum protection of drivetrain components.
Using the c ...