Chevrolet Sonic Owner's Manual: DIC Menu Items
Press MENU to view the DIC menus. Some items display in the upper display area,
some in the lower display area, and others use both the upper and lower display
areas. Use 
to scroll through the menu
items. Not all items are available on every vehicle. The following is a list of
all possible menu items:
- Units
- Language
- Tire Learn
- Remaining Oil Life
Units
This menu is not available while the vehicle is moving. Press SET/CLR while the
unit display is active and move to
change units when UNIT SET is displayed. Press SET/ CLR to confirm the setting.
You will have to select 1, 2, or 3 for the unit display. 1 is Imperial units, 2
is US units, and 3 is metric units. This will change the displays on the cluster
and DIC to the type of measurements you select.
Language
This menu is not available while the vehicle is moving. Press SET/CLR while the
language display is active and move
to change the language of the displays when LANG SET is displayed. You will have
to select 1 or 2 for the language display. 1 is Alphabet and 2 is Arabic Numeral.
Press SET/ CLR to confirm the setting.
Tire Learn
This menu is not available while the vehicle is moving. This display allows for matching of the TPMS sensors. See Tire Pressure Monitor System and Tire Pressure Monitor Operation.
Remaining Oil Life
This menu is not available while the vehicle is moving. This display shows an
estimate of the oil's remaining useful life. If 99
% is displayed, that means 99% of the current oil life remains.
When the remaining oil life is low, the Code 82 message will appear on the display. The oil should be changed as soon as possible. See Engine Oil. In addition to the engine oil life system monitoring the oil life, additional maintenance is recommended in the Maintenance Schedule. See Maintenance Schedule.
Remember, the oil life display must be reset after each oil change. It will not reset itself. Also, be careful not to reset the oil life display accidentally at any time other than when the oil has just been changed.
It cannot be reset accurately until the next oil change. To reset the engine oil life system, press the SET/CLR button while the oil life display is active. See Engine Oil Life System.
DIC Operation and Displays
The DIC has different displays which can be accessed by using the DIC buttons
on the turn signal lever on the left side of the steering wheel. The DIC displays
trip, fuel, and warning messages if ...
Vehicle Messages
...
Other materials:
Parking Brake Indicator Switch Replacement
Removal Procedure
Remove the front floor console. Refer to
Front Floor Console Replacement.
Ensure that the park brake lever is in the fully released
position.
Disconnect the electrical connector from the park
brake warning indicator switch.
Remove the par ...
Rear Compartment Lid Nameplate Replacement (Sedan)
Rear Compartment Lid Nameplate Replacement
Callout
Component Name
1
Rear Compartment Lid Nameplate
Caution: Refer to Exterior Trim Emblem Removal Caution.
Procedure
The part and surface should be ...
Manual Transmission Shift Lever Cable Adjustment
Special Tools
DT-527-A Adjuster or 5mm drill bit
For equivalent regional tools, refer to Special Tools.
Note: Not using the specified tools may lead to shift system mis-adjustment.
Remove the floor console. Refer to
Front Floor Console Replacement.
Lift upward an ...
0.0055