Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Front Floor Console Cover Replacement (Manual Transmission)

Chevrolet Sonic Repair Manual / Body / Body Interior / Dashboard Assembly / Front Floor Console Cover Replacement (Manual Transmission)

Removal Procedure

    Use a flat bladed plastic trim tool in order to release the retainers
  1. Use a flat bladed plastic trim tool in order to release the retainers securing the console cover?€‰(1) to the console assembly.

  2. Reach under the console cover assembly?€‰(1) and release the retainer tabs securing the transmission shift lever boot?€‰(2) to the console cover assembly.

  3. Feed the transmission control lever boot assembly thru the opening in the console cover assembly?€‰(1).
  4. Remove the console cover assembly?€‰(1) from the vehicle.
Installation Procedure

    Position the console cover assembly?€‰(1) to the console assembly.
  1. Position the console cover assembly?€‰(1) to the console assembly.
  2. Feed the transmission control lever boot assembly thru the opening in the console cover assembly?€‰(1).

  3. Snap the transmission control lever boot assembly?€‰(2) to the console cover?€‰(1) ensuring the retainer tabs lock the boot assembly to the cover.
  4. Install the cover assembly to the console.
Front Floor Console Cover Replacement (Automatic Transmission)
Front Floor Console Cover Replacement Callout Component Name 1 Front Floor Console Cover Assembly Procedures Appl ...

Front Floor Console Cup Holder Replacement
Front Floor Console Cup Holder Replacement Callout Component Name Preliminary Procedure Remove the front floor console assembly ...

Other materials:

Hazard Warning Flashers
(Hazard Warning Flasher): Press and momentarily hold this button to make the front and rear turn signal lamps flash on and off. This warns others that you are having trouble. Press and momentarily hold again to turn the flashers off. ...

Roof Front Header Panel Replacement
Removal Procedure Warning: Refer to Approved Equipment for Collision Repair Warning. Note: The roof front header panel is made of Ultra High Strength Steel and should be replaced only at factory joints. Repairing or sectioning of this part is not recomme ...

Lock Cylinder Coding - Ignition
The ignition lock cylinder uses 8 key cut positions, 1?E. The ignition cylinder tumblers (3) are located on alternate sides of the cylinder (5). They are not snap-in and are not self-retaining. It follows the key code with the first tumbler being the first depth of the ke ...

© 2014-2024 Copyright www.csmans.com
 
0.0089