|
Callout |
Component Name |
|---|---|
|
1 |
Driver or Passenger Seat Inner Recliner Finish Cover Cap Procedure
Use a flat-bladed tool to release the cap from the recliner cover. |
|
2 |
Driver or Passenger Seat Inner Recliner Finish Cover Fastener (Qty:?€‰2) Caution: Refer to Fastener Caution.
8?€‰Y (71?€‰lb?€‰in) |
|
3 |
Driver or Passenger Seat Inner Recliner Finish Cover Procedure
Firmly grasp the upper area of the finish cover that folds over the seat cushion frame, pull upward and then outboard to disengage the finish cover from the seat cushion frame. |
Front Seat Cushion Cover and Pad Replacement
Front Seat Cushion Outer Trim Panel ReplacementTire and Loading Information Label
A vehicle-specific Tire and Loading Information label is attached to the vehicle's
center pillar (B-pillar). The Tire and Loading Information label shows the number
of occupant seating positions (1), and the maximum vehicle capacity weight (2) in
kilograms and pounds.
The Tire and Loadi ...
Seat Belt Latch Stop Installation
Seat Belt Latch Stop Installation
Callout
Component Name
Preliminary Procedure
Locate the hole in the seat belt webbing where the original seat
belt stop button was located.
If the original hole in the seat belt webbing i ...
Low and Reverse Clutch Assembly and Low and Reverse Clutch Plate Installation
Low and Reverse Clutch Assembly and Low and Reverse Clutch Plate Installation
Callout
Component Name
1
Low and Reverse Clutch Assembly (OWC)
Note:
The Low and Reverse Clutch Assembly should rotat ...