|
Callout |
Component Name |
|---|---|
|
1 |
Front Seat Riser Finish Cover Caution: Do not twist the cover during removal. Twisting the cover may cause the component to break. Procedure
Remove the finish cover by firmly grasping the front or rear of the cover and pulling the cover outward then upward to disengage it from the track. |
Front Seat Back Recliner Handle ReplacementTire-to-Wheel Match-Mounting (Vectoring)
Note: After remounting a tire to a wheel or after replacing a tire
and/or a wheel, remeasure the tire and wheel assembly runout in order to verify
that the amount of runout has been reduced and brought to within tolerances.
Ensure that the tire and wheel assembly is properly balanced ...
Battery Negative Cable Disconnection and Connection
Battery Negative Cable Disconnection and Connection
Callout
Component Name
Preliminary Procedures
Turn on the radio and record all of the radio pre-set stations.
Ensure that all lamps and accessories are turned off.
Tu ...
Evaporative Emission Canister Replacement
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the EVAP canister cover fasteners (1) and cover (2).
Warning: Do not breathe the air through the EVAP component
tubes or hoses. The fuel vapors inside t ...