Chevrolet Sonic Repair Manual: Front Side Door Window Regulator Replacement

Chevrolet Sonic Repair Manual / Body / Glass & Windows / Window Control / Window Regulator / Front Side Door Window Regulator Replacement

Front Side Door Window Regulator Replacement
Callout	Component Name
Warning: Refer to Glass and Sheet Metal Handling Warning. Preliminary Procedure Remove the front side door window from the guide. Do Not remove the window from the vehicle, raise the window to the fully up position, tape in place. Refer to Front Side Door Window Replacement.
1	Front Side Door Window Regulator Screw (Qty:?€‰4) Caution: Refer to Fastener Caution. Procedure Remove the front side door water deflector. Loosen the window guide nuts, Do Not remove the nuts from the guide. Disconnect the electric connector from the regulator motor. Tighten 11?€‰Y (97?€‰lb?€‰in)
2	Front Side Door Window Regulator Procedure Transfer the front side door window regulator motor. Refer to Front Side Door Window Regulator Motor Replacement. Inspect the door window for proper operation before installing the door trim panel.

Front Side Door Window Regulator Motor Replacement

Front Side Door Window Regulator Motor Replacement Callout Component Name Warning: Refer to Glass and Sheet Metal Handling War ...

Rear Side Door Window Regulator Handle Replacement

Rear Side Door Window Regulator Handle Replacement Callout Component Name 1 Rear Side Door Window Regulator Handle Clip ...

Other materials:

Dome Lamp Bulb Replacement
Dome Lamp Bulb Replacement Callout Component Name Preliminary Procedure Remove the windshield header courtesy lamp. Refer to Windshield Header Courtesy Lamp Replacement 1 Dome Lamp Bulb ...

Adhesive Installation of Rear Windows
Warning: Refer to Glass and Sheet Metal Handling Warning. Use a urethane adhesive systems which meet GM Specification GM?€‰3651G. Remove all mounds or loose pieces of urethane adhesive from the pinchweld area. If the original window is being reused, remove all but approxi ...

Instrument Panel Center Molding Replacement (With U58)
Instrument Panel Center Molding Replacement Callout Component Name 1 Instrument Panel Center Molding Assembly Procedure Use a flat bladed plastic trim tool in the shown locations, then rotate the trim tool 90 ...

0.0066