Chevrolet Sonic Repair Manual: Front Side Door Window Weatherstrip Replacement

Chevrolet Sonic Repair Manual / Body / Body Exterior / Weatherstripping / Front Side Door Window Weatherstrip Replacement

Front Side Door Window Weatherstrip Replacement
Callout	Component Name
Preliminary Procedures Remove front side door trim panel. Refer to Front Side Door Trim Replacement. Remove the outside rearview mirror. Refer to Outside Rearview Mirror Replacement.
1	Front Side Door Window Weatherstrip Procedure Place the window in the fully down position. Remove the water deflector. Grasp both upper corners of the window weatherstrip, pull downward releasing the assembly from the door frame. Insert the weatherstrip downward in the front and rear channel until fully seated. Position the window weatherstrip in the upper rear corner of the frame, work the weatherstrip around the door frame. Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the channels. Inspect the door window for proper operation before installing the door trim panel.

Front Side Door Weatherstrip Replacement - Door Side

Front Side Door Weatherstrip Replacement - Door Side Callout Component Name 1 Front Side Door Weatherstrip Upper Retaine ...

Hood Rear Weatherstrip Replacement

in Hood Rear Weatherstrip Replacement Callout Component Name 1 Hood Rear Weatherstrip Procedure The hood rear weat ...

Other materials:

Rear Wheelhouse Liner Replacement (Hatchback - Right)
Rear Wheelhouse Liner Replacement Callout Component Name Preliminary Procedure Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. 1 Rear Wheelhouse Panel Liner ...

Body Rear Seat Back Trim Panel Replacement (with AMA/AM7)
Body Rear Seat Back Trim Panel Replacement Callout Component Name Preliminary Procedure Remove the body side trim panel. Refer to Body Side Trim Panel Replacement. 1 Body Rear Seat Back Trim Pane ...

Bushing and Mating Shaft Inspection
Note: Proper bushing and corresponding mating shaft inspection should be performed before replacing the bushing, shaft, and in some cases, the component which houses the bushing. Thoroughly clean and dry the bushing and shaft surfaces before inspecting for damage. Any of the followin ...

0.006