
|
Callout |
Component Name |
|---|---|
|
1 |
Hood Rear Weatherstrip Procedure
The hood rear weatherstrip is held in place with 10?€‰plastic retainers that are part of the air inlet grille. Carefully pull the weatherstrip to the right/left to release from the retainers on the air inlet grille. |
Front Side Door Window Weatherstrip Replacement
Liftgate Weatherstrip ReplacementInstrument Panel Center Molding Replacement (Without U58)
Instrument Panel Center Molding Replacement
Callout
Component Name
1
Instrument Panel Center Molding Assembly
Procedure
Use a flat bladed plastic trim tool in the shown locations, then
rotate the trim tool 90 ...
Instrument Panel Outer Trim Cover Replacement
Instrument Panel Outer Trim Cover Replacement
Callout
Component Name
1
Instrument Panel Outer Trim Cover (Qty:?€‰2)
Procedures
Use a flat bladed plastic trim tool in order to disengage the retainers
securi ...
Camshaft Replacement
Special Tools
EN-422 Installer
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Note: Take extreme care to prevent any scratches, nicks or
damage to the camshafts and caps bearing surfaces.
Remove the timing belt rear cover ( ...