|
Callout |
Component Name |
|---|---|
|
1 |
Liftgate Weatherstrip Procedure
Clean the area where the seal will be mounted. Use a suitable solvent with a mixture of 50?€‰percent isopropyl alcohol and 50?€‰percent water by volume, or high-flash naphtha. |
Hood Rear Weatherstrip Replacement
Rear Compartment Lid Weatherstrip ReplacementRear Seat Back Cushion Removal and Installation (60%)
Rear Seat Back Cushion Removal and Installation
Callout
Component Name
Preliminary Procedure
Remove the rear seat cushion. Refer to Rear Seat Cushion Removal
and Installation.
Remove the rear seat center retractor side be ...
Camshaft Seal Replacement
Special Tools
EN 422 Installer
EN 45000 Remover
For equivalent regional tools, refer to Special Tools
Removal Procedure
Remove the intake and exhaust camshaft sprocket. Refer to Camshaft Sprocket
Replacement.
Note: Do not damage the sealing surfaces.
...
Thrust Washer and Bearing Cleaning and Inspection
Warning: Wear safety glasses to avoid injury when using compressed
air or any cleaning solvent. Bodily injury may occur if fumes are inhaled
or if skin is exposed to chemicals.
Caution: Do not allow the bearings to spin. Turn them slowly by
hand. Spinning the beari ...