Chevrolet Sonic Repair Manual: Fuel Tank Draining
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Remove the fuel tank filler cap.
- Insert a suitable suction hose into the fuel tank filler pipe.
- Attach a suitable suction hose to the hose used with the hand or air operated pump devise.
- Using a hand or air operated pump drain as much fuel from the tank as possible.
Warning:
Refer to Gasoline/Gasoline Vapors Warning.
Note:
The fuel tank must be drained with a suitable, commercially-available fuel removal unit and suction hose - follow safety regulations and national legislation. The fuel tank is fitted with a refill limit float valve. This is located on the filler neck in the fuel tank. To prevent damaging the refill limit float valve, a suitable suction hose must be used. In the presence of fuel vapors or escaping fuel - observe safety regulations and national legislation. Store drained fuel in a suitable, sealable container.
Fuel System Description
Fuel System Overview
The fuel system is an electronic returnless on-demand design. A returnless
fuel system reduces the internal temperature of the fuel tank by not returning
hot fuel f ...
Fuel Tank Filler Pipe Replacement
Removal Procedure
Remove the bracket fastener (1).
Lift and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
Remove the fuel tank filler pip ...
Other materials:
Brake Pedal Position Sensor Replacement
Removal Procedure
Remove the instrument panel lower trim pad cover. Refer to Instrument
Panel Lower Trim Pad Cover Replacement.
Disconnect the brake pedal position sensor electrical connector.
Remove the brake pedal position sensor bolt (1).
Remove t ...
Evaporator Air Temperature Sensor Replacement (LHD)
Evaporator Air Temperature Sensor Replacement
Callout
Component Name
1
Evaporator Air Refrigerant Temperature Sensor
Procedures
Disconnect the refrigerant temperature sensor electrical connector.
Twist an ...
Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
Pipe Joint Compound
Note: Three types of sealer are commonly used in engines. These
are RTV sealer, anaerobic gasket eliminator sealer, and pipe joint compound.
The correct sealer and amount must be used in the proper location to prevent
oil leaks. DO NOT interchange the 3&# ...
0.0059