Warning
With head restraints that are not installed and adjusted properly, there is a greater chance that occupants will suffer a neck/ spinal injury in a crash. Do not drive until the head restraints for all occupants are installed and adjusted properly.
Front SeatsEmblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Tire and Wheel Assembly Runout Measurement - Off Vehicle
Raise and support the vehicle.
Mark the location of the wheels to the wheel studs and mark the specific
vehicle position on each tire and wheel – LF, LR, RF, RR.
Remove the tire and wheel assemblies from the vehicle.
Closely inspect each tire for proper and even bead seating.
If an ...
Timing Belt Idler Pulley Installation
Special Tools
EN-45059 Angle Meter
For equivalent regional tools, refer to Special Tools.
Caution: Refer to Fastener Caution.
Caution: Refer to Torque-to-Yield Fastener Caution.
Re-cut the timing belt idler pulley thread.
Install the timing belt idler pulley̴ ...