Chevrolet Sonic manuals

Chevrolet Sonic Owner's Manual: Lane Departure Warning (LDW)

For vehicles with this feature, read the entire section before using it.

Warning

The LDW system is an aid to help the vehicle stay in the driving lane. It does not steer the vehicle. The LDW system may not:

If LDW only detects lane markings on one side of the road, it will only warn you when departing the lane on the side where it has detected a lane marker. Even with LDW, always keep your attention on the road and maintain proper vehicle position within the lane, or vehicle damage, injury, or death could occur. Always keep the windshield clean and do not use LDW in bad weather conditions.

When the vehicle crosses a detected lane marking, the LDW indicator will flash and three beeps will sound. LDW will not warn if the turn signal is on or if a sharp maneuver is made.

When the System Does Not Seem to Work Properly
The RVC system may not work properly or display a clear image if: The RVC is turned off. See “Turning the Rear Camera System On or Off” earlier in this section. It is dark. The sun or t ...

How the System Works
The LDW camera sensor is on the windshield ahead of the rearview mirror. To turn LDW on and off, press the LANE DEPART button on the steering wheel. The control indicator will light when LDW is o ...

Other materials:

Automatic Transmission Fluid
How to Check Automatic Transmission Fluid It is not necessary to check the transmission fluid level. A transmission fluid leak is the only reason for fluid loss. If a leak occurs, take the vehicle to your dealer and have it repaired as soon as possible. There is a special procedure for checkin ...

Interior Lighting Systems Description and Operation
Interior Lamps The interior lighting consist of two groups. This first group includes lamps that may not be dimmed. Dome/reading lamps Rear compartment courtesy lamp Dome Lamps When any door is opened, the associated door jamb switch closes providing a door ...

Instrument Panel Center Molding Replacement (Without U58)
Instrument Panel Center Molding Replacement Callout Component Name 1 Instrument Panel Center Molding Assembly Procedure Use a flat bladed plastic trim tool in the shown locations, then rotate the trim tool 90 ...

© 2014-2026 Copyright www.csmans.com
 
0.0063