Chevrolet Sonic Owner's Manual: OnStar Overview

Chevrolet Sonic Owner's Manual / OnStar / OnStar Overview

If equipped, this vehicle has a comprehensive, in-vehicle system that can connect

If equipped, this vehicle has a comprehensive, in-vehicle system that can connect to a live Advisor for Emergency, Security, Navigation, Connection, and Diagnostic Services.

The OnStar system status light is next to the OnStar buttons. If the status light is:

Solid Green: System is ready.
Flashing Green: On a call.
Red: Indicates a problem.

Press or call 1-888-4-ONSTAR (1-888-466-7827)
to speak to an Advisor.

Press to:

Make a call, end a call, or answer an incoming call.
Give OnStar Hands-Free Calling voice commands.
Give OnStar Turn-by-Turn Navigation voice commands. Requires the available Directions and Connections service plan.

Press to: to connect to a live Advisor
to:

Verify account information or update contact information.
Get driving directions. Requires the available Directions and Connections service plan.
Receive On-Demand Diagnostics for a check of the vehicle’s key operating systems.
Receive Roadside Assistance.

Press the OnStar Emergency button
to get a priority connection to an Emergency Advisor available 24/7 to:

Get help for an emergency.
Be a Good Samaritan or respond to an AMBER Alert.
Get assistance in severe weather or other crisis and evacuation routes.

OnStar Services

Emergency With Automatic Crash Response, the built-in system can automatically connect to help in most crashes, even if help cannot be requested. Press to connect to an Emergency Advisor. GPS t ...

Other materials:

Cruise Control Description and Operation
Cruise control is a speed control system that maintains a desired vehicle speed under normal driving conditions at speeds above 40 km/h (25 mph). Steep grades may cause variations in the selected vehicle speeds. The following are the main components of the Cruise Control System: ...

Instrument Panel Center Molding Replacement (With U58)
Instrument Panel Center Molding Replacement Callout Component Name 1 Instrument Panel Center Molding Assembly Procedure Use a flat bladed plastic trim tool in the shown locations, then rotate the trim tool 90 ...

Ignition Coil Replacement
Special Tools EN-6009 Remover and Installer Ignition Coil For equivalent regional tools, refer to Special Tools. Removal Procedure Remove the engine wiring harness guide (1) from the cylinder head. Disconnect the ignition coil electrical connector (2). ...

0.0075