Chevrolet Sonic Repair Manual: Park Brake and P (Park) Mechanism Check
Warning:
When you are doing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case it begins to roll. Be ready to apply the regular brake at once should the vehicle begin to move.
Park on a fairly steep hill, with the vehicle facing downhill. Keeping your foot on the regular brake, set the parking brake.
- To check the parking brake's holding ability: With the engine running and the transmission in N (Neutral), slowly remove foot pressure from the regular brake pedal. Do this until the vehicle is held by the parking brake only.
- To check the P (Park) mechanism's holding ability: With the engine running, shift to P (Park). Then release the parking brake followed by the regular brake.
Contact your dealer if service is required.
Electronic Park Lock Description and Operation
If the vehicle is equipped with automatic transmission and a floor mounted console
gear shift, it has an electronic park lock system (EPL). The EPL system purpose
is to prevent the ignition key fr ...
Control Valve Body Assembly Assemble (Gen 1)
Control Valve Body Assembly Assemble
Callout
Component Name
1
Valve Body Ball Check Valve (Qty: 6)
...
Other materials:
SIR Service Precautions
General Service Instructions
Warning: When performing service on or near the SIR components
or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling
and Enabling . Failure to observe the correct procedure could cause deployment
of the SIR components, person ...
Rear Spring, Insulator, and Jounce Bumper Replacement
Rear Spring, Insulator, and Jounce Bumper Replacement
Callout
Component Name
Preliminary Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
1
Rear Spring
Proced ...
Timing Belt Replacement
Special Tools
EN-6333 Timing Belt Tensioner Locking Pin
EN-6340 Camshaft Locking Tool
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Note: If the timing belt is being replaced due to the maintenance
schedule interval, then the timing belt t ...
0.005