Chevrolet Sonic Repair Manual: Power Steering Control Module Programming and Setup
The following service procedures require either a programming or a setup event performed for a complete repair.
- Power Steering Control Module Replacement
-
If the steering column power steering control module needs to be is replaced, the power steering control module needs to be programmed with the following procedures:
- Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS).
- Perform the SPS function Power Steering Control Module – Programming and follow the on-screen instructions.
- Clear DTCs after completing the programming procedure.
- Power Steering Control Module Reprogramming
-
Do not reprogram the power steering control module unless directed by a service procedure or a service bulletin.
- Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS).
- Perform the SPS function Power Steering Control Module – Programming and follow the on-screen instructions.
- Clear DTCs after completing the programming procedure.
Steering Control
...
Other materials:
Mode Control Cable Replacement (LHD)
Mode Control Cable Replacement
Callout
Component Name
Preliminary Procedures
Remove the heater and air conditioning control.Refer to Heater and
Air Conditioning Control Replacement
Remove the instrument panel lower trim p ...
Exhaust System Replacement
Removal Procedure
Special Tools
CH-6614 Chain Pipe Cutter
For equivalent regional tools, refer to Special Tools.
Warning: Refer to Protective Goggles and Glove Warning
Warning: Refer to Exhaust Service Warning.
Raise and support the vehicle. Refer to Lifting ...
Drive Range, Fifth Gear (Gen 2)
As vehicle speed increases, the transmission control module (TCM) processes input
signals from the automatic transmission input and output speed sensors, the throttle
position sensor and other vehicle sensors to determine the precise moment to command
ON the normally-low 35R pressure control s ...
0.006