Chevrolet Sonic Repair Manual: Chassis
- Brakes
- Steering
- Hydraulic Steering
- Steering Control
- Steering Gear Assembly
- Tie Rods and Linkage
- Steering Wheel and Column
- Suspension
- Drivetrain and Front Suspension Frame Replacement
- Drivetrain and Front Suspension Frame Skid Plate Replacement
- Front Suspension Description and Operation
- Front and Rear Suspension Modification Kit Installation
- Rear Axle Replacement
- Rear Suspension Description and Operation
- Special Tools
- Trim Height Inspection
- Ball Joint Inspection
- Rear Spring, Insulator, and Jounce Bumper Replacement
- Rear Compartment Lid Hinge Torque Rod Replacement
- Lower Control Arm Replacement
- Front Wheel Bearing and Hub Replacement
- Rear Wheel Bearing and Hub Replacement (Disc Brake)
- Rear Wheel Bearing and Hub Replacement (Drum Brake)
- Front Wheel Bearing and Hub Replacement
- Hub/Axle Flange and Wheel Stud Runout Inspection
- Rear Wheel Bearing and Hub Replacement (Disc Brake)
- Rear Wheel Bearing and Hub Replacement (Drum Brake)
- Tire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
- Steering Knuckle Replacement
- Liftgate Strut Replacement
- Strut Assembly Removal and Installation
- Strut, Strut Component, or Spring Replacement
- Shock Absorber Disposal
- Shock Absorber Replacement
- Strut and Shock Absorber Inspection
- Strut and Shock Absorber Inspection (Shock Absorber)
- Rear Spring, Insulator, and Jounce Bumper Replacement
- Stabilizer Shaft Link Replacement
- Stabilizer Shaft Replacement
- Brake Control and Vehicle Dynamics
- Wheels/Tires
Windshield Wiper Motor Replacement
Windshield Wiper Motor Replacement
Callout
Component Name
Preliminary Procedure
Remove the wiper system module. Refer to Windsh ...
Brakes
...
Other materials:
Roof Outer Panel Replacement (4NB)
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Disable the SIR system. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove all ...
General Description
The factory installed tires are designed to operate satisfactorily with loads
up to and including the full rated load capacity when these tires are inflated to
the recommended pressures.
The following factors have an important influence on tire life:
Correct tire pressures
Correct wheel ...
Throttle Body Assembly Installation
Install a NEW throttle body seal.
Install the throttle body (1).
Caution: Refer to Fastener Caution.
Install the 4 throttle body bolts (2) and tighten to
8 Y (71 lb in).
...
0.0109