Chevrolet Sonic Repair Manual: Drivetrain and Front Suspension Frame Skid Plate Replacement
- Removal Procedure
-
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the mounting bolts (1) for the front suspension frame skid plate.
- Remove the front suspension frame skid plate (2).
- Installation Procedure
-
- Position the front suspension frame skid plate (2) on the frame.
- Install the front suspension frame skid plate mounting bolts (2) and
tighten to 22 Y (16 lb ft)
.
Caution:
Refer to Fastener Caution.
Drivetrain and Front Suspension Frame Replacement
Special Tools
EN-45059 Angle Meter
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Support the radiator and condenser from above using the upper brackets
...
Front Suspension Description and Operation
The front suspension has 2 primary purposes:
Isolate the driver from irregularities in the road surface.
Define the ride and handling characteristics of the vehicle.
The front suspension ab ...
Other materials:
Rocking the Vehicle to Get it Out
Turn the steering wheel left and right to clear the area around the front wheels.
Turn off any traction system. Shift back and forth between R (Reverse) and a low
forward gear, spinning the wheels as little as possible. To prevent transmission
wear, wait until the wheels stop spinning before s ...
Front Fog Lamp Bulb Replacement
Front Fog Lamp Bulb Replacement
Callout
Component Name
Preliminary Procedure
Remove either the left front or right front wheelhouse liner. Refer
to Front Wheelhouse Liner Replacement.
Disconnect the electrical connector t ...
Camshaft Sprocket Installation
Install the intake camshaft sprocket (3).
Install the intake camshaft position sensor exciter wheel (2) and the intake
camshaft sprocket bolt (1), but do not tighten yet.
Install the exhaust camshaft sprocket.
Note: Tightening of camshaft sprocket bolts will ...
0.0106