Chevrolet Sonic Repair Manual: Suspension
- Drivetrain and Front Suspension Frame Replacement
- Drivetrain and Front Suspension Frame Skid Plate Replacement
- Front Suspension Description and Operation
- Front and Rear Suspension Modification Kit Installation
- Rear Axle Replacement
- Rear Suspension Description and Operation
- Special Tools
- Trim Height Inspection
- Ball Joint Inspection
- Rear Spring, Insulator, and Jounce Bumper Replacement
- Rear Compartment Lid Hinge Torque Rod Replacement
- Lower Control Arm Replacement
- Front Wheel Bearing and Hub Replacement
- Rear Wheel Bearing and Hub Replacement (Disc Brake)
- Rear Wheel Bearing and Hub Replacement (Drum Brake)
- Front Wheel Bearing and Hub Replacement
- Hub/Axle Flange and Wheel Stud Runout Inspection
- Rear Wheel Bearing and Hub Replacement (Disc Brake)
- Rear Wheel Bearing and Hub Replacement (Drum Brake)
- Tire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
- Steering Knuckle Replacement
- Liftgate Strut Replacement
- Strut Assembly Removal and Installation
- Strut, Strut Component, or Spring Replacement
- Shock Absorber Disposal
- Shock Absorber Replacement
- Strut and Shock Absorber Inspection
- Strut and Shock Absorber Inspection (Shock Absorber)
- Rear Spring, Insulator, and Jounce Bumper Replacement
- Stabilizer Shaft Link Replacement
- Stabilizer Shaft Replacement
Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
Ensure that the steering wheel is set in a straight ahead position.
Loosen the tie rod jam nut (1).
Adjust the toe to specification by turning the inner tie rod (2). Refer
...
Drivetrain and Front Suspension Frame Replacement
Special Tools
EN-45059 Angle Meter
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Support the radiator and condenser from above using the upper brackets
...
Other materials:
Protecting Exterior Bright Metal Moldings
Caution
Failure to clean and protect the bright metal moldings can result in a hazy
white finish or pitting. This damage would not be covered by the vehicle warranty.
The bright metal moldings on the vehicle are aluminum. To prevent damage always
follow these cleaning instructions:
Be sure ...
Engine Coolant Thermostat Housing Replacement (LUW)
Removal Procedure
Remove the battery tray. Refer to Battery Tray Replacement.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Drain the cooling system. Refer to Cooling System Draining and Filling.
Disconnect the engine harness conn ...
Gear Position Sensor Replacement
Gear Position Sensor Replacement
Callout
Component Name
Preliminary Procedure
Unclip the engine control module (ECM) and bracket from the battery tray.
1
Gear Position Sensor Magnet Bolt
...
0.0073