Vehicle Speed Sensor Replacement
GeneralEmblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Data Link Communications Description and Operation
Note: This is an overview of different serial data buses used by GM
devices to communicate with each others. Use Data Communication Schematics to
find out which serial data buses are configured for a specific vehicle.
Circuit Description
There are many components in a vehicle t ...
Camshaft Installation
Special Tools
EN-422 Installer
For equivalent regional tools, refer to Special Tools.
Note: Coat with MoS 2 lubricating paste. Refer to Adhesives, Fluids,
Lubricants, and Sealers.
Install the intake camshaft (1).
Note: Note the identification mark ...