Chevrolet Sonic Repair Manual: Tires and Wheels Description and Operation (Equipment)
- GM Recommended Tire Balancer
-
Hunter RF33 Road Force balancer or equivalent with the following options:
- Auto Clamp – allows for centering repeatability and prevent damage to the wheel.
- Wheel Lift – helps prevent wheel damage and assists in the accuracy of the placement to the collet.
- Laser System for Weight Placement – for highly accurate weight placement and to verify the morning calibration procedure.
- Integrated Printer – to document the RFV results and VIN for each tire and wheel assembly.
- 20-2472-1 GM Collet and Flange Plate Kit – 11 degree short collets offer better centering and reduce protrusion into chrome-clad wheels, which interferes with proper seating. Flange plates further protect the wheel by placing the mounting pressure at the tapered lug holes.
- Specific Software – co-developed with GM.
Note:
This equipment is recommended to increase repeatability and reduce variation of the assembled product.
- Equipment Maintenance
-
- Spindle shaft and hub face should be cleaned at regular intervals.
- Do not lube the hub face.
- Mounting cones, collets and other mounting devices, should be cleaned,
lubed and inspected for burs.
Note:
Machine must be calibrated regularly.
Wheel Weight Cutter
3M wheel weights are made of a unique, flexible and conformable material. Precision cut length weights improve wheel balance and vehicle ride quality.
- Tire Changer / Mounter
-
GM Recommended Hunter TCA34W Auto 34 Leverless Tire Changer, including the following options:
- Wheel Lift
- RP6-G1000A87 Flange Plate Kit for Tire Changer
Note:
The Auto34 is capable of exercising both of the tire beads at once to ensure proper seating, and offer the greatest amount of torque. The wheel lift and leverless design minimizes damage to both tire and wheels.
Tires and Wheels Description and Operation
There are two types of tire and wheel balancing: static and dynamic.
Static balance is the equal distribution of weight around the wheel. Assemblies
that are statically unbalanced cause a bouncing ...
Tires and Wheels Description and Operation (Tire Identification)
Identification
Accessory and warranty replacement must use TPC spec tires.
An outboard orientation stripe is added to the tread surface, with an
offset toward the outboard tire fa ...
Other materials:
Lock Cylinder Coding - Ignition
The ignition lock cylinder uses 8 key cut positions, 1–8. The ignition cylinder
tumblers (3) are located on alternate sides of the cylinder (5). They are not snap-in
and are not self-retaining. It follows the key code with the first tumbler being
the first depth of the ...
Fuel Injection Fuel Rail Assembly Replacement
Removal Procedure
Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection
and Connection.
Remove engine cover. Refer to Engine Cover Replacement.
Remove the fuel feed pipe from fuel injection fuel rail. Refer to Fuel
Feed Pipe Replacement.
Re ...
I-FCW system operation
The Nissan Armada I-FCW system becomes active at speeds above approximately 3
MPH (5 km/h), ensuring functionality during most driving scenarios.
When a potential forward collision risk is detected, the Nissan Armada system
immediately alerts the driver by flashing the vehicle-ahead detecti ...
0.0054