|
Callout |
Component Name |
|---|---|
|
Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:
Failure to do so may cause future personal injury. Warning: Do not repair or replace the seat stitching or seams in the seat back trim cover with an internal mounted seat side airbag module. Replace the complete seat back trim cover from the OEM. Non-OEM seat stitching may cause improper airbag deployment which could result in personal injury.
|
|
|
1 |
Seat Side Inflatable Restraint Module Nut (Qty:?€‰2) Caution: Refer to Fastener Caution
4?€‰Y (35?€‰lb?€‰in) |
|
2 |
Driver or Passenger Seat Side Inflatable Restraint Module Procedure
|
Front Seat Heater Control Module Replacement
Replacing Airbag System Parts after a CrashSpecial Tools (MIT Tool Instructions)
Bluetooth Pairing for Vehicles with
Radio RPO: UF7
Either reset the pin code on the radio to 0000, or go under Device Info on
the radio and see what the pin code is (to enter it later on the MIT).
Turn the BT discoverable ON in the radio Bluetooth
settings.
Press Pair De ...
Valve Stem Oil Seal and Valve Spring Replacement
Special Tools
207649 Rod Hairpin Clips
547324 Flange Screws
EN-840 Pliers / Remover
EN-958 Installer
EN-45059 Angle Meter
EN-50717 Kit
J-43649–2 Rods
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the spark plugs. Refer to Spa ...
Fuel Injection Fuel Rail Assembly Replacement
Removal Procedure
Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection
and Connection.
Remove engine cover. Refer to Engine Cover Replacement.
Remove the fuel feed pipe from fuel injection fuel rail. Refer to Fuel
Feed Pipe Replacement.
Re ...