Chevrolet Sonic Owner's Manual: Radio Settings

Chevrolet Sonic Owner's Manual / Instruments and Controls / Vehicle Personalization / Radio Settings

Select and the following may display:

Auto Volume
Radio Favorites
Radio Tune Bar
Radio Text
XM Categories
Radio Factory Settings

Auto Volume

This feature adjusts the radio volume to compensate for road and wind noise as the vehicle speeds up or slows down, so that the volume level is consistent.

Select Off, Low, Medium, or High.

Radio Favorites

This feature sets the number of favorite pages displayed.

Press < or > to select the desired number.

Radio Tune Bar

Select to display the radio station tune bar.

Select On or Off.

Radio Text

Select to display the radio broadcast information.

Select On or Off.

XM Categories

Select to set the selection of XM categories.

Radio Factory Settings

Select to restore the radio to the factory settings.

Time & Date Settings

Select to change the settings: Set Time Format: Select 12h or 24h. Set Date Format: Press < or > to select the date display. Set Time & Date: Select, then press or to adjust th ...

Connection Settings

Select and the following may display: Bluetooth Settings Change Ringtone Ringtone Volume Bluetooth Settings Select this feature to: Connect, disconnect, or delete a device Change or ...

Other materials:

Scheduling Service Appointments
When the vehicle requires warranty service, contact your dealer and request an appointment. By scheduling a service appointment and advising the service consultant of your transportation needs, your dealer can help minimize your inconvenience. If the vehicle cannot be scheduled into the service ...

Strut Assembly Removal and Installation
Special Tools CH 49375 Strut Rod Nut Socket For equivalent regional tools, refer to Special Tools Removal Procedure Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. ...

Main Shaft Assemble (Gen 1)
Special Tools 3-0207944 Main Shaft Tapered Bearing Insert Tool For equivalent regional tools, refer to Special Tools. Install the 4th gear bearing assembly (1). Note: The 3rd gear blocking ring lugs must be aligned with the 3rd/4th gear synchronizer assembly groov ...

0.0078