Chevrolet Sonic manuals

Nissan Armada 2025-2026 Owner's Manual: RCTA system operation

Nissan Armada rear cross traffic alert system diagram and indicators

  1. Side indicator light
  2. Vehicle information display
  3. Steering-wheel-mounted controls (right side)

The Nissan Armada RCTA system enhances driver awareness by monitoring cross traffic when reversing. When the transmission is shifted into R (Reverse) and the vehicle speed remains below approximately 5 MPH (8 km/h), the system becomes active.

If an approaching vehicle is detected from either side, the Nissan Armada emits an audible warning (single chime), and the corresponding side indicator light flashes on the side where the vehicle is approaching.

Nissan Armada rear cross traffic alert detection example
Example

The Nissan Armada utilizes radar sensors (A) located on both sides of the rear bumper to monitor cross traffic. These sensors can detect vehicles at distances of up to approximately 66 ft (20 m), providing early warning to the driver.

Basic information
WARNING Failure to properly follow the usage guidelines and safety instructions for the RCTA system in the Nissan Armada may result in serious injury or even death. The Rear Cross Traffic Alert ...

How to enable/disable the RCTA system
Vehicle information display Steering-wheel-mounted controls (right side) Follow these steps to activate or deactivate the Nissan Armada RCTA system: 1. Press the button until the &quo ...

Other materials:

Seat Adjustment
Manual Seats To adjust a manual seat: 1. Pull the handle at the front of the seat. 2. Slide the seat to the desired position and release the handle. 3. Try to move the seat back and forth to be sure it is locked in place. See Seat Adjustment. Seat Height Adjuster If available, move the le ...

Exhaust Manifold with Catalytic Converter Replacement (LUW)
Exhaust Manifold with Catalytic Converter Replacement Callout Component Name Warning: Refer to Protective Goggles and Glove Warning. Warning: Refer to Exhaust Service Warning. Preliminary Procedure ...

Neutral - Engine Running (Gen 1)
When the gear selector is moved to the Neutral (N) position, the hydraulic and electrical system operation is identical to Park (P) range. However, if Neutral is selected after the vehicle was operating in Reverse (R), the normally-high 35R pressure control solenoid 2 is commanded OFF and the ...

В© 2014-2026 Copyright www.csmans.com
 
0.0071