Chevrolet Sonic Repair Manual: Rear Side Door Weatherstrip Replacement - Body Side

Chevrolet Sonic Repair Manual / Body / Body Exterior / Weatherstripping / Rear Side Door Weatherstrip Replacement - Body Side

Rear Side Door Weatherstrip Replacement - Body Side
Callout	Component Name
Preliminary Procedures Remove the upper center pillar trim. Refer to Center Pillar Upper Trim Panel Replacement. Remove the lower center pillar trim. Refer to Center Pillar Lower Trim Panel Replacement Remove the carpet retainer. Refer to Rear Side Door Opening Floor Carpet Retainer Replacement.
1	Rear Side Door Weatherstrip Body Side Procedure Starting in the center bottom of the weatherstrip, pull the weatherstrip upward and away from the pinch-weld flange. Start in the center bottom of the pinch-weld flange. Ensure that the weatherstrip and retainers are fully seated on the flange before installing the front carpet retainer. Inspect the door for proper operation.

Rear Side Door Upper Front Auxiliary Weatherstrip Retainer Replacement

Rear Side Door Upper Front Auxiliary Weatherstrip Retainer Replacement Callout Component Name 1 Front Side Door Upper Fr ...

Rear Side Door Weatherstrip Replacement - Door Side

Rear Side Door Weatherstrip Replacement - Door Side Callout Component Name 1 Rear Side Door Weatherstrip Procedure ...

Other materials:

Front Bumper Fascia Opening Lower Cover Replacement
Front Bumper Fascia Opening Lower Cover Replacement Callout Component Name 1 Front Bumper Fascia Opening Lower Cover Push-In Retainer 2 Front Bumper Fascia Opening Lower Cover Bolt (Qty:?€� ...

Evaporative Emission Canister Replacement (Steel Tank)
Removal Procedure Remove the evaporative emission canister bracket fasteners (1). Disconnect the purge solenoid valve electrical connector (1). Disconnect the evaporative emission canister vent hose (2). Disconnect the evaporative emission c ...

Intake Camshaft Removal
Remove the camshaft bearing cap bolts in a spiral sequence as shown one turn at a time until there is no spring tension pushing on the camshaft. Note: Mind the markings on the camshaft bearing caps to ensure they will be installed in the same position. Remove the ...

0.0084