This vehicle may have the RVC system. Read this entire section before using it.
The RVC system can assist the driver when backing up by displaying a view of the area behind the vehicle.
Warning
The RVC system does not display children, pedestrians, bicyclists, animals, or any other object located outside the camera's field of view, below the bumper, or under the vehicle. Perceived distances may be different from actual distances. Do not back the vehicle using only the RVC screen, during longer, higher speed backing maneuvers, or where there could be cross traffic. Failure to use proper care before backing may result in injury, death, or vehicle damage. Always check behind and around the vehicle before backing.
An image appears on the infotainment screen when the vehicle is shifted into R (Reverse). The infotainment screen goes to the previous screen after approximately 4 seconds once the vehicle is shifted out of R (Reverse).
To return to the previous screen sooner, do one of the following:
Guidelines
The RVC system has a guideline overlay that can help the driver align the vehicle when backing into a parking spot.
To turn the guidelines on or off:
1. Shift into P (Park).
2. From the home page on the infotainment system, select Settings.
3. Select Rear Camera Options.
4. Select Guidelines.
Rear Vision Camera Error Messages
SERVICE REAR VISION CAMERA SYSTEM: This message can display when the system is not operating properly.
If any other problem occurs or if a problem persists, see your dealer.
Cleaning the System
Rear Vision Camera LocationEngine Heater
The engine heater can provide easier starting and better fuel economy during
engine warm-up in cold weather conditions at or below −18°C (0°F). Vehicles with
an engine heater should be plugged in at least four hours before starting.
1. Turn off the engine.
2. Open the hood and unwrap ...
Front and Rear Suspension Modification Kit Installation
Installation Instruction Part Number
23158166
23158167
Tools Required
CH 49375 Strut Rod Nut Socket
For equivalent regional tools, refer to Vehicle Service Manual.
Front Strut Removal Procedure
Remove the air inlet grille panel. Refer to Vehicle Service Manual.
Raise a ...
Manual Transmission Shift Lever Cable Adjustment
Special Tools
DT-527-A Adjuster or 5mm drill bit
For equivalent regional tools, refer to Special Tools.
Note: Not using the specified tools may lead to shift system mis-adjustment.
Remove the floor console. Refer to
Front Floor Console Replacement.
Lift upward an ...