The rear window wiper motor is located inside the hatchback door and is directly connected to the rear window wiper. Ignition voltage is supplied to the rear wiper motor through the wiper switch. The hatchback rear window washer systems equipped with a separate washer fluid pump, hose, and nozzle. Ignition voltage is supplied to the washer pump through the wiper switch. Attached to the reservoir is a washer pump, which pumps fluid through a hose to the nozzle mounted on the hatch.
Vehicle Yaw Sensor Learn
The yaw sensor does not require calibration often. Calibration of the yaw rate
sensor might be required after certain service procedures are performed. Some of
these procedures are as follows:
Electronic brake control module (EBCM) replacement
Multi-axis acceleration sensor replacement
...
Front Wheel Drive Shaft Inner Joint and Boot Replacement
Special Tools
DT-35910 Drive Axle Boot Clamp Pliers
For equivalent regional tools, refer to Special Tools.
Disassemble Procedure
Note: There are types of inner joints available. If the inner
joint is connected with the CV style joint, the inner joint is not serviced
separa ...
Tire and Wheel Balancing (Balancing/Wheel Weights)
Use 3M wheel weights, refer to Adhesives, Fluids, Lubricants, and Sealers
for application.
Surface of the wheel must be clean and dry.
All tire and wheel assemblies are to be checked for static tolerance of
2 grams and not more than 20 grams per plane, using cut-to-length weight produc ...