Chevrolet Sonic Owner's Manual: SiriusXM Radio Messages
UPDATING: The encryption code in the receiver is being updated, and no action is required. This process should take no longer than 30 seconds.
NO SIGNAL: The system is functioning correctly, but the vehicle is in a location that is blocking the SiriusXM signal. When the vehicle is moved into an open area, the signal should return.
LOADING: The audio system is acquiring and processing audio and text data. No action is needed. This message should disappear shortly. OFF AIR: This channel is not currently in service. Tune in to another channel.
CH UNAVAILABLE: This previously assigned channel is no longer assigned. Tune to another station. If this station was one of the presets, choose another station for that preset button.
RADIO ID: If tuned to channel 0, this message alternates with the SiriusXM Radio eight-digit radio ID label. This label is needed to activate the service.
CHECK XM TUNER: If this message does not clear within a short period of time, the receiver could have a fault. Consult with your dealer.
Storing an SiriusXM Channel
Drivers are encouraged to set up XM channel favorites while the vehicle is not
moving. Tune to favorite stations using the pushbuttons, favorites button, and steering
wheel controls. See Defensive ...
Radio Reception
Frequency interference and static can occur during normal radio reception if
items such as cell phone chargers, vehicle convenience accessories, and external
electronic devices are plugged into th ...
Other materials:
Hood Rear Weatherstrip Replacement
in
Hood Rear Weatherstrip Replacement
Callout
Component Name
1
Hood Rear Weatherstrip
Procedure
The hood rear weatherstrip is held in place with 10?€‰plastic retainers
that are part of the air inlet grille. ...
Instrument Panel Insulator Replacement
Instrument Panel Insulator Replacement
Callout
Component Name
Preliminary Procedures
Disable the SIR system. Refer to SIR Disabling and Enabling.
Remove the passenger inflatable restraint instrument panel lower
module ...
Air Cleaner Element Replacement
Removal Procedure
Disconnect mass air flow sensor wiring harness plug (2) from mass air
flow sensor (3).
Unclip mass air flow sensor wiring harness retainer clip from air cleaner
housing (1).
Remove the air cleaner outlet duct clamp̴ ...
0.0054