Warning
When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured.
1. Before starting this check, be sure there is enough room around the vehicle.
2. Apply both the parking brake and the regular brake.
Do not use the accelerator pedal, and be ready to turn off the engine immediately if it starts.
3. For automatic transmission vehicles, try to start the engine in each gear. The vehicle should start only in P (Park) or N (Neutral). If the vehicle starts in any other position, contact your dealer for service.
For manual transmission vehicles, put the shift lever in Neutral, push the clutch pedal down halfway, and try to start the engine. The vehicle should start only when the clutch pedal is pushed down all the way to the floor. If the vehicle starts when the clutch pedal is not pushed all the way down, contact your dealer for service.
Vehicle Storage
Automatic Transmission Shift Lock Control Function CheckLicense Plate Lamp
Lamp Assembly
Bulb Assembly
Bulb Socket
Bulb
Lamp Assembly
To replace one of these bulbs:
Push the left end of the lamp assembly toward the right.
Turn the lamp assembly down to remove it.
Turn the bulb socket (1) counterc ...
Rear Seat Back Cushion Latch Release Knob Bezel Replacement
Rear Seat Back Cushion Latch Release Knob Bezel Replacement
Callout
Component Name
1
Rear Seat Back Cushion Latch Release Handle Bezel
Procedure
Use a flat-bladed tool to tilt the rear of the handle upward, then l ...
Fuel Tank Replacement
Removal Procedure
Disconnect the battery negative cable. Refer to
Battery Negative Cable Disconnection and Connection.
Relieve the fuel pressure. Refer to
Fuel Pressure Relief.
Drain the fuel Tank. Refer to
Fuel Tank Draining.
Lift and support the vehicle. Refer ...