Chevrolet Sonic Repair Manual: Stationary Window Description
Most stationary windows, specifically windshields, are retained to the body with adhesive which adheres the window to the body, increasing structural integrity. The reinstallation of the windows with adhesive requires complete replacement of the adhesive bead, and is known as the full cut method. All stationary windows must use a adhesive systems which meet GM Specification GMW-15672.
Special Tools
Illustration
Tool Number/ Description
BO-24402-A
J-24402-A
Glass Sealant Cold Knife Remover
equalizerm ...
Stationary Window Waterleak Repair
Warning: If any water enters the vehicle interior up to the level
of the carpet or higher and soaks the carpet, the sensing and diagnostic module
(SDM) and the SDM harness connector may need ...
Other materials:
Passenger Compartment Air Filter Replacement (LHD)
Passenger Compartment Air Filter Replacement
Callout
Component Name
Preliminary Procedure
Remove IP compartment. Refer to Instrument Panel Lower Compartment Replacement.
1
Passenger Compartment A ...
Intake Manifold Installation
Clean the sealing surfaces.
Install the intake manifold (1) along with a NEW intake manifold gasket.
Caution: Refer to Fastener Caution.
Install the 6 intake manifold bolts (1) and tighten to 20 Y (15 lb ft).
...
Exhaust Camshaft Removal
Remove the camshaft bearing cap bolts in a spiral sequence as shown one
turn at a time until there is no spring tension pushing on the camshaft.
Note: Mind the markings on the camshaft bearing caps to ensure
they will be installed in the same position.
Remove the ...
0.0069