Chevrolet Sonic Repair Manual: Sunroof Window Height and Opening Fit Adjustment

Chevrolet Sonic Repair Manual / Body / Glass & Windows / General / Sunroof Window Height and Opening Fit Adjustment

Note:

Correct adjustment cannot be achieved if the sunroof window is closed from vent position.

Cycle the sunroof window from full open to closed position.

Note:

Do Not remove or lower headliner to access sunroof window screws.

Loosen the adjusting screws on the window.
Adjust the corners of the front window panel using the following guidelines:

Adjust the front of the sunroof window to?€‰0.0?€‰mm?€‰??’?€‰1.0?€‰mm (0.0?€‰in?€‰??’?€‰0.04?€‰in?€‰) below the top surface of the roof panel.
Adjust the rear center line of the sunroof window to?€‰2?€‰mm?€‰ to ?€‰3?€‰mm (0 .08?€‰in?€‰ to?€‰0.12?€‰in?€‰) below the top surface of the roof panel.

Caution:

Refer to Fastener Caution.

Tighten the sunroof window adjustment screws to 5?€‰Y (44?€‰lb?€‰in)

Cycle sunroof window through all positions.

Inspect the sunroof window adjustment. Adjust if necessary.

Stationary Window Waterleak Repair

Warning: If any water enters the vehicle interior up to the level of the carpet or higher and soaks the carpet, the sensing and diagnostic module (SDM) and the SDM harness connector may need ...

Sunroof Window Replacement

Sunroof Window Replacement Callout Component Name 1 Sunroof Window Bolt?€‰(Qty:?€‰4) Caution: Refer to F ...

Other materials:

OnStar Description and Operation
This OnStar® system consists of the following components: Telematics communication interface control module OnStar® three button assembly Microphone Cellular antenna Navigation antenna Bluetooth® antenna (If equipped) Back up battery (If equipped) This system also interfaces wi ...

Drive Range, First Gear Engine Braking (Gen 1)
When the gear selector lever is moved to the Drive (D) range from the Neutral (N) position, the transmission will provide engine braking. In this operating range, the normally-low 1234 pressure control solenoid 5 is commanded ON and, in the engine braking mode, the following changes occur with ...

Oil Pump Cleaning and Inspection
Remove the external rotor with the internal rotor. Visually inspect the components. Install the external and the internal rotors. Inspect the axial clearance of the rotors in respect to the control unit housing upper edge. Specifications Permissible measurement is 0.02?E.058 ...

0.0053