Callout |
Component Name |
---|---|
1 |
Torque Converter and Differential Housing Seal |
2 |
Fluid Pump Assembly |
3 |
Fluid Pump Bolts M8 x 33 (Qty: 7) Caution: Refer to Fastener Caution.
10 Y (89 lb in) then rotate the bolt an additional 45 degrees Special Tool
EN-45059 Angle Meter or equivalent For equivalent regional tools, refer to Special Tools. |
4 |
Front Differential Carrier Bearing Assembly |
5 |
Front Differential Ring Gear |
6 |
Front Differential Ring Gear Retainer Note: Install the retainer with the taper facing away from the ring gear. |
7 |
Front Differential Carrier Baffle |
8 |
Front Differential Carrier Baffle Bolts M6 x 25 (Qty: 2) Tighten
12 Y (106.21 lb in) |
Removing the Flat Tire and Installing the Spare Tire
1. Do a safety check before proceeding. See If a Tire Goes Flat.
2. Remove the wheel cover, if the vehicle has one, to reach the wheel bolts.
3. Turn the wheel nuts counterclockwise to loosen them. Do not remove them yet.
4. Place the jack at the position marked with a half circle.
5. In ...
OnStar Additional Information
Transferring Service
Press to request account transfer
eligibility information. The Advisor can assist in canceling or removing account
information. If OnStar receives information that vehicle ownership has changed,
OnStar may send a voice message to the vehicle, requesting updated account i ...
Secondary Air Injection System Description
The Secondary Air Injection System aids in the reduction of hydrocarbon exhaust
emissions during a cold start. This occurs when the start-up engine coolant temperature
(ECT) is between −10 to +56°C (14?E33°F), the intake air temperature (IAT) is greater
than −10°C (14°F) and it ...