Chevrolet Sonic Owner's Manual: Voice Recognition
The voice recognition system uses commands to control the system and dial phone numbers.
Noise: The system may not recognize voice commands if there is too much background noise. Do not point the center air vents directly upward.
When to Speak: A tone sounds to indicate that the system is ready for a voice command. Wait for the tone and then speak.
How to Speak: Speak clearly in a calm and natural voice.
Bluetooth Controls
Use the buttons located on the infotainment system and the steering wheel to
operate the Bluetooth system.
Steering Wheel Controls
(Push to Talk): Press to answer
incoming calls, confirm system ...
Audio System
When using the Bluetooth system, sound comes through the vehicle's front audio
system speakers and overrides the audio system. Use the
/VOL knob during a call to change the
volume level. The ...
Other materials:
Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
Sedan Taillamp Shown, Hatchback Taillamp Similar
1. Back-up Lamp
2. Turn Signal Lamp
3. Stop Lamp/Taillamp
4. Sidemarker Lamp
To replace one of these bulbs:
1. Open the trunk.
2. Remove the two screws, which secure the taillamp assembly.
3. Remove the taillamp assembly by pulling it stra ...
Park Brake and P (Park) Mechanism Check
Warning: When you are doing this check, the vehicle could begin to
move. You or others could be injured and property could be damaged. Make sure
there is room in front of the vehicle in case it begins to roll. Be ready to
apply the regular brake at once should the vehicle begin to move. ...
Knock Sensor System Description
Circuit/System Description
The knock sensor system enables the engine control module (ECM) to control
the ignition timing for the best possible performance while protecting the engine
from potentially damaging levels of detonation. The ECM uses the knock sensor
system to test for ...
0.0089