|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the instrument panel insulator, if equipped. |
|
|
1 |
Blower Motor Resistor Screw (Qty: 2) Caution: Refer to Fastener Caution. |
|
2 |
Blower Motor Resistor Procedure
Disconnect the wiring connector. |
Heater and Air Conditioning Evaporator and Blower Module Removal and Installation
HeatingRear Wheel Bearing and Hub Replacement (Drum Brake)
Rear Wheel Bearing and Hub Replacement
Callout
Component Name
Preliminary Procedures
Raise and support the vehicle. Refer to Lifting and Jacking the
Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Rem ...
Catalytic Converter Replacement (LUV)
Removal Procedure
Warning: Refer to Exhaust Service Warning.
Warning: Refer to Protective Goggles and Glove Warning.
Remove the exhaust manifold heat shield. Refer to Exhaust Manifold Heat
Shield Replacement.
Remove the catalytic converter heated oxygen senso ...
2-6 Clutch Piston Installation (6T30)
2-6 Clutch Piston Installation
Callout
Component Name
1
2?E Clutch Piston Assembly
Note:
Position the 2?E piston air bleed and large slot toward the
top of the case.
DT-48271 seal protector ...