Callout |
Component Name |
---|---|
Preliminary Procedure
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. |
|
1 |
Rear Wheelhouse Panel Liner Screw (Qty:?€‰5) Caution: Refer to Fastener Caution.
3?€‰Y (27?€‰lb?€‰in) |
2 |
Rear Wheelhouse Panel Liner Nut (Qty:?€‰4) Tighten
2?€‰Y (18?€‰lb?€‰in) |
3 |
Rear Wheelhouse Panel Liner Push-In Retainer |
4 |
Rear Wheelhouse Panel Liner |
Load Compartment (Hatchback)
The load compartment cover can be used to conceal objects under it or removed
and placed on the bottom of the load compartment to carry larger loads.
To remove the load compartment cover:
Lift up on the load compartment cover and pull out.
Store the load compartment cover on the bottom of ...
Multi-Axis Acceleration Sensor Module Programming and Setup
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the Multi-axis Acceleration Sensor or Inertia
Sensor Module (IMU) is not properly configured with the correct calibration
software, the Electronic Brake Control Module will ...
Crankshaft and Bearing Installation
Special Tools
EN-45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to Special Tools
Note: Inspect the installation position.
Install the crankshaft bearing clips, oil bearing clips.
Install the crankshaft.
Note: Inspect the installation position.
...