Chevrolet Sonic Repair Manual: Frame and Structure
- Body Side Frame Rocker Reinforcement Replacement
- Driver or Passenger Seat Back Cushion Frame Replacement
- Driver or Passenger Seat Cushion Frame Replacement
- Drivetrain and Front Suspension Frame Replacement
- Front Compartment Front Insulator Cover Replacement
- Front Wheelhouse Liner Inner Front Extension Replacement (Left SIde)
- Front Wheelhouse Liner Inner Front Extension Replacement (Right SIde, LWE, LUW)
- Front Wheelhouse Liner Inner Front Extension Replacement (Right Side, LUV)
- Front Wheelhouse Liner Replacement (Front)
- Front Wheelhouse Liner Replacement (Rear)
- Rear Wheelhouse Liner Replacement (Hatchback - Left)
- Rear Wheelhouse Liner Replacement (Hatchback - Right)
- Rear Wheelhouse Liner Replacement (Sedan - Left)
- Rear Wheelhouse Liner Replacement (Sedan - Right)
- Rear Wheelhouse Panel Liner Extension Replacement
- Special Tools
- Center Pillar Reinforcement Replacement
- Drivetrain and Front Suspension Frame Skid Plate Replacement
Rear Side Door Window Weatherstrip Replacement (Sedan)
Rear Side Door Window Weatherstrip Replacement
Callout
Component Name
Preliminary Procedures
The rear door side window weatherstrip ...
Body Side Frame Rocker Reinforcement Replacement
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Warning: Refer to Glass and Sheet Metal Handling Warning.
Note ...
Other materials:
Removing the Flat Tire and Installing the Spare Tire
1. Do a safety check before proceeding. See If a Tire Goes Flat.
2. Remove the wheel cover, if the vehicle has one, to reach the wheel bolts.
3. Turn the wheel nuts counterclockwise to loosen them. Do not remove them yet.
4. Place the jack at the position marked with a half circle.
5. In ...
Front Wheel Bearing and Hub Replacement
Special Tools
CH-50559 Wheel Hub/Bearing Remover Kit
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the steering knuckle assembly from the vehicle. Refer to Steering
...
Neutral - Engine Running (Gen 2)
When the gear selector is moved to the Neutral (N) position, the hydraulic and
electrical system operation is identical to Park (P) range. However, if Neutral
is selected after the vehicle was operating in Reverse (R), the normally-low 35R
pressure control solenoid is commanded OFF and the fol ...
0.0059