Chevrolet Sonic Repair Manual: Drivetrain and Front Suspension Frame Skid Plate Replacement
- Removal Procedure
-
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the mounting bolts?€‰(1) for the front suspension frame skid plate.
- Remove the front suspension frame skid plate?€‰(2).
- Installation Procedure
-
- Position the front suspension frame skid plate?€‰(2) on the frame.
- Install the front suspension frame skid plate mounting bolts?€‰(2) and
tighten to 22?€‰Y (16?€‰lb?€‰ft)
.
Caution:
Refer to Fastener Caution.
Center Pillar Reinforcement Replacement
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Warning: Refer to Glass and Sheet Metal Handling Warning.
Note ...
Glass & Windows
...
Other materials:
Seat Belt System Description and Operation
Restraint System
Note: If the vehicle has been in a collision, refer to Repairs
and Inspections Required After a Collision.
The vehicle has front and rear seat belts that are the primary means of occupant
restraint. Seat belts help to keep the occupants inside the passenger ...
Tire Pressure Monitor Operation
This vehicle may have a Tire Pressure Monitor System (TPMS). The TPMS is designed
to warn the driver when a low tire pressure condition exists. TPMS sensors are mounted
onto each tire and wheel assembly, excluding the spare tire and wheel assembly.
The TPMS sensors monitor the air pressure in ...
Ignition Coil Installation
Special Tools
EN-6009 Remover and Installer Ignition Module
For equivalent regional tools, refer to Special Tools.
Install the ignition coil (1) and remove EN-6009 remover and installer
(2).
Caution: Refer to Fastener Caution.
Install the 2 ...
0.0076