Chevrolet Sonic Owner's Manual: Disarming the System
To disarm the system, either unlock the doors using the RKE transmitter, or start the vehicle with a recognized transmitter in the vehicle.
To avoid setting off the alarm by accident:
- Press
on the RKE transmitter. - Start the vehicle.
To avoid setting off the alarm by accident:
- Lock the vehicle after all occupants have left the vehicle and all doors are closed.
- Always unlock a door with the RKE transmitter.
Unlocking the driver door with the key will not disarm the system or turn off the alarm.
Arming the AlarmSystem
1. Close all doors, the trunk/liftgate, and the hood.
2. Lock the vehicle in one of two ways:
Use the RKE transmitter.
With a door open, press on the
interior of the door.
3. After 30 se ...
How to Detect a Tamper Condition
If is pressed on the transmitter
and the horn chirps three times, an alarm occurred previously while the alarm system
was armed. ...
Other materials:
Oil Pan Installation
Special Tools
EN-49980 Guidance Pins
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces from old sealing material, dirt, oil and grease.
Note: The sealing bead should be applied close to the inner edge
of the oil pan. Take care that the oil suctio ...
Intake Camshaft Removal
Remove the camshaft bearing cap bolts in a spiral sequence as shown one
turn at a time until there is no spring tension pushing on the camshaft.
Note: Mind the markings on the camshaft bearing caps to ensure
they will be installed in the same position.
Remove the ...
Differential Case Assemble
Special Tools
J-810721 Axle Shaft Seal Remover Support Base
R-0407011 Bearing Race Remover
R-0407012 Differential Carrier Cone Bearing Cap Driver
R-0007761 Universal Handle for Pullers and Installers
S-9407194 Speed Sensor Impeller Ring Installer
S-9407195 Pinion Gear Case Bearing I ...
0.0115