Chevrolet Sonic Owner's Manual: Engine Oil Pressure Light
Caution
Lack of proper engine oil maintenance can damage the engine. Driving with the engine oil low can also damage the engine. The repairs would not be covered by the vehicle warranty. Check the oil level as soon as possible. Add oil if required, but if the oil level is within the operating range and the oil pressure is still low, have the vehicle serviced. Always follow the maintenance schedule for changing engine oil.
This light should come on briefly as the engine is started. If it does not come on, have the vehicle serviced by your dealer.
If the light comes on and stays on, it means that oil is not flowing through the engine properly. The vehicle could be low on oil and might have some other system problem. See your dealer.
Tire Pressure Light
For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on
briefly when the engine is started. It provides information about tire pressures
and the TPMS.
When the Light Is O ...
Low Fuel Warning Light
This light comes on for a few seconds when the ignition is turned on as a check
to indicate it is working. If it does not come on, have it fixed.
This light comes on when the vehicle is low on fu ...
Other materials:
Trim Height Inspection
Trim Height Measurement
Trim height is a predetermined measurement relating to vehicle ride height.
Incorrect trim heights can cause the vehicle to bottom out over bumps, damage
to the suspension components and symptoms similar to wheel alignment problems.
Check the trim heights wh ...
Battery Current Sensor Replacement
Removal Procedure
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Disconnect the battery current sensor from the body harness connector.
Unclip the battery current sensor from the battery tray.
Remove the battery ...
Intake Manifold Disassemble
Remove the fuel injection rail ground cable nut (1).
Remove the 2 fuel injection rail bolts (2).
Remove the fuel injection fuel rail assembly (3).
Remove the intake manifold gasket (4).
Remove the 2 manifold absolute pressure sensor bolts ...
0.0064