Chevrolet Sonic manuals

Chevrolet Sonic Owner's Manual: Tire Pressure Light

For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on


For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on briefly when the engine is started. It provides information about tire pressures and the TPMS.

When the Light Is On Steady

This indicates that one or more of the tires are significantly underinflated.

Stop as soon as possible, and inflate the tires to the pressure value shown on the Tire and Loading Information label. See Tire Pressure.

When the Light Flashes First and Then Is On Steady

If the light flashes for about a minute and then stays on, there may be a problem with the TPMS. If the problem is not corrected, the light will come on at every ignition cycle. See Tire Pressure Monitor Operation.

Engine Coolant Temperature Warning Light
This light comes on briefly while starting the vehicle. If it does not, have the vehicle serviced by the dealer. If the system is working normally the indicator light goes off. Caution The engi ...

Engine Oil Pressure Light
Caution Lack of proper engine oil maintenance can damage the engine. Driving with the engine oil low can also damage the engine. The repairs would not be covered by the vehicle warranty. Check th ...

Other materials:

New Vehicle Break-In
Caution The vehicle does not need an elaborate break-in. But it will perform better in the long run if you follow these guidelines: . Do not drive at any one constant speed, fast or slow, for the first 805 km (500 mi). Do not make full-throttle starts. Avoid downshifting to brake or slo ...

Evaporative Emission Canister Vent Solenoid Valve Replacement
Evaporative Emission Canister Vent Solenoid Valve Replacement Callout Component Name Preliminary Procedures Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the e ...

Control Solenoid Valve and Transmission Control Module Assembly Inspection
Verify the conditions listed below do not exist. Carefully inspect the control solenoid valve assembly connectors and pins (1, 2, 4, 6) for the condition. Repair or replace as necessary. Damage Bent pins Debris Broken retaining tab Contamination Verify there is ...

В© 2014-2026 Copyright www.csmans.com
 
0.0055