Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Liftgate Strut Replacement



Liftgate Strut Replacement

Callout

Component Name

1

Liftgate Strut

Warning:

When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Caution:

Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.

Procedure

  1. Release the locking tabs on the strut.
  2. Ensure the clip is fully seated when the strut is reinstalled. If the clip cannot be fully seated, a new strut should be installed.
Liftgate Side Applique Replacement (Hatchback)
Liftgate Side Applique Replacement Callout Component Name Preliminary Procedure Open and support the rear liftgate assembly. Re ...

Liftgate Trim Finish Panel Replacement (Hatchback)
Liftgate Trim Finish Panel Replacement Callout Component Name 1 Liftgate Trim Finish Panel Fastener Caution: Ref ...

Other materials:

Hood Primary Latch Release Cable Replacement
iv Hood Primary Latch Release Cable Replacement Callout Component Name Preliminary Procedures Remove the radiator opening upper cover. Refer to Front Opening Upper Cover Replacement. Remove the air inlet grille. Refer to A ...

Repairs and Inspections Required After a Collision
Warning: Restraint systems can be damaged in a collision. To help avoid injury and ensure that all parts in need of replacement are replaced: Replace any seat belt system that was in use during the collision serious enough to deploy any automatic restraint device such as air bags ...

Brake Rotor Assembled Lateral Runout Measurement
Special Tools CH-41013 Rotor Surfacing Kit CH-42450-A Wheel Hub Resurfacing Kit CH-45101 Hub and Wheel Runout Gauge CH-45101-100 Conical Brake Rotor Washers For equivalent regional tools, refer to Special Tools. Warning: Refer to Brake Dust Warning. Note: B ...

В© 2014-2026 Copyright www.csmans.com
 
0.0064