|
Callout |
Component Name |
|---|---|
Preliminary Procedures
|
|
|
1 |
Rear Wheel Bearing/Hub Mounting Bolt (Qty 4) Caution: Refer to Fastener Caution. Procedure
Remove the electrical connector for the rear wheel speed sensor. Tighten
58 Y (43 lb ft) |
|
2 |
Rear Wheel Bearing/Hub Assembly Procedure
Ensure that the rear wheel bearing/hub is properly aligned with the rear axle to allow access to the wheel speed sensor connector. |
Rear Brake Hose Replacement (Body to Axle - Drum Brake)
Special ToolsTorque Lock (Automatic Transmission)
If you are parking on a hill and you do not shift the transmission into P (Park)
properly, the weight of the vehicle may put too much force on the parking pawl in
the transmission. You may find it difficult to pull the shift lever out of P (Park).
This is called “torque lock.� To prevent t ...
Park - Engine Running (Gen 1)
When the gear selector lever is in the Park (P) position, fluid is drawn into
the pump through the transmission fluid filter assembly. Line pressure is then directed
to the following valves:
Fluid Pressure Directed in Preparation for a Shift
Manual Valve
Mechanically controlled by ...
Window washer fluid
WARNING
Washer antifreeze solutions are toxic. Always store them in labeled containers
and keep them away from children and animals.
Maintain the washer fluid level in your Nissan Armada by checking it periodically
and refilling as needed, especially when the low washer fluid warning ind ...