Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Sunroof Housing Rear Drain Hose Replacement

Chevrolet Sonic Repair Manual / Body / Roof - Fixed, Leisure / Moonroof/Sunroof / Sunroof Housing Rear Drain Hose Replacement



Sunroof Housing Rear Drain Hose Replacement

Callout

Component Name

Preliminary Procedures

  1. It is only necessary to lower the headliner. Only do those steps in the headliner replacement procedure that will lower the headliner enough to gain access to the part. Refer to Headlining Trim Panel Replacement.
  2. Remove the body side trim panel. Refer to Body Lock Pillar Upper Trim Panel Replacement.
  3. Remove the rear window panel trim. Refer to Rear Window Panel Trim Replacement.
  4. Remove the rear compartment trim on the side being repaired. Refer to Rear Compartment Side Trim Replacement - Right Side.

1

Sunroof Housing Rear Drain Hose Retainers (Qty:?€‰4)

2

Sunroof Housing Rear Drain Hose

Procedure

  1. Remove the sunroof housing rear drain hose and grommet from the rear compartment quarter panel.
  2. Water test the vehicle before installing the headliner to ensure no water leaks.
Sunroof Housing Front Drain Hose Replacement
Sunroof Housing Front Drain Hose Replacement Callout Component Name Preliminary Procedure It is only necessary to lower the hea ...

Sunroof Module Assembly Replacement
Sunroof Module Assembly Replacement Callout Component Name Preliminary Procedures Remove the sunroof window. Refer to Sunroof Windo ...

Other materials:

Brake Fluid Level Indicator Switch Replacement
Removal Procedure Disconnect the brake fluid level indicator switch electrical connector. Using a small, flat-bladed tool, lift the locking tab on the underside of the brake fluid level indicator switch (1) and remove the switch. Inspect the maste ...

Crankshaft Balancer Removal
Special Tools EN-652 Flywheel Holder For equivalent regional tools, refer to Special Tools. Install the EN-652 holder (1). Lock the flywheel (2) or the automatic transmission flex plate via the starter ring gear. Remove and DISCARD the crankshaft balancer bo ...

Turbocharger Installation
Special Tool EN-49942 Holding Wrench For equivalent regional tools, refer to Special Tools. Clean the sealing surfaces. Replace the connect fittings on the turbocharger coolant feed pipe and the turbocharger coolant return pipe. Refer to Turbocharger Disassemble and Turbocharger Ass ...

© 2014-2019 Copyright www.csmans.com
   
0.1514